Catherine’s Wheel

Catherine's Wheel Being Pulled Well, I finished my first attempt at a “Catherine’s Wheel” last night – a piece of line laundry that is supposed to spin in the wind. It was rather easy to make except that the instructions were about as clear as mud. As a result, I don’t know if it’s going to spin or not – if it’s not constructed properly, it will inflate but not spin. Unfortunately, there wasn’t any wind either last night or today so I ended up taking my boy down to the ocean where, of course, there also wasn’t any wind (not even the slightest breeze). So. . .what does one do? Have your boy run with it, of course! The picture at the left shows just that. 

As is evident, my Catherine’s Wheel did inflate but I still haven’t been able to tell if it will spin. My boy’sCatherine's Wheel Flashing By test run did prove that it will at least appear as a circle. Sadly a couple of the bridles came loose during it’s maiden voyage. I used Dacron line and tied it to the wheel using sheet bends (as the instructions directed). Unfortunately, the Dacron is too slippery and a couple of the knots came undone. I’m going to super-glue each knot tonight as tying them on was a bit of a pain.

Catherine's Wheel at the Finish Line Even with the lack of wind and the problems with the bridles, I think that the Catherine’s Wheel turned okay. I’m just hoping that it will spin. Only time will tell that – I’m going to try again tomorrow. Keeping my fingers crossed!